高频地波雷达下的多目标跟踪数据处理

根据高频地波雷达监测海上低速移动目标的要求及该类雷达的特点,提出了一种与高频地波雷达目标跟踪相适应的多目标跟踪数据处理方案。在该方案中对BTC(bayes tracking confirm)方法与BTT(bayes tracking termination)方法进行了改进,解决了上述两种方法在高频地波雷达实际应用中存在的问题。提出了贝叶斯准则与次数判定相结合的跟踪起始和终结方法。模拟结果表明,该方案能够稳定、有效地实现高频地波雷达密集回波下的多目标跟踪。     

发动机机油滤清器虑层强度分析及优化

针对机油滤清器工作工况下进出口压差、机油滤层强度及导流桩高度等问题, 通过试验测试与仿真相结合, 对滤清器初步设计进行了评估及优化, 以确保滤清器在工作工况下进出口压降及滤层强度能满足要求. 首先进行滤层性能试验, 得到滤层的惯性阻力系数和黏性阻力系数; 再通过滤层多孔介质CFD分析, 对滤清器进出口压降进行分析计算. 结果表明: 在-18℃、25℃和70℃的工况下, 进出口压降都小于10kPa, 满足相关要求. 针对滤层的最大主应力超过其抗拉强度的问题, 通过CAE仿真分析, 优化滤层与导流桩间隙, 将滤层最大主应力由110.1MPa降至36.99MPa, 小于其抗拉强度42.8MPa.     

靶场光测多站图像多目标判读技术

靶场光测图像处理的一个突出难题是如何分辨图像上出现的大量小目标。利用单站序列图像上目标的运动关联、目标在多站图像上像点之间的对极几何约束关系,提出了靶场多站图像多目标判读的新技术,采用单站序列图像目标卡尔曼运动轨迹预测及跟踪识别技术,以及多站图像对极几何约束同名目标匹配技术,突破了传统方法仅进行单站图像判读的局限。仿真结果证明其能有效解决多站、多目标的判读问题,已成功应用于我们研制的多套靶场图像判读系统中。     

X射线对CCD噪声影响的分析及滤波方法研究

通过实验分析了X射线对CCD的影响以及射线噪声的特点 ,并针对这种噪声的性质提出了菱形均值滤波器。经过计算机仿真滤波实验和实际应用 ,与递归与非递归中值滤波器作了对比 ,表明该滤波器不但能有效滤除脉冲噪声 ,而且能够较好地保持图像边缘和细节。     

超导共面波导带通滤波器的设计

本介绍了采用共面波导间隙作为阻抗变换器而设计的Chebyshev型带通滤波器。通过电磁模拟计算分析了共面波导间隙的归一化阻抗转换参量，在此基础上设计了高温超导薄膜共面波导带通滤波器，并对设计的滤波器原型进行了模拟和优化。     

Theoretical and experimental study of Chen chaotic system with notch filter feedback control

Since the past two decades, the time delay feedback control method has attracted more and more attention in chaos control studies because of its simplicity and efficiency compared with other chaos control schemes. Recently, it has been proposed to suppress low-dimensional chaos with the notch filter feedback control method, which can be implemented in a laser system. In this work, we have analytically determined the controllable conditions for notch filter feedback controlling of Chen chaotic system in terms of the Hopf bifurcation theory. The conditions for notch filter feedback controlled Chen chaoitc system having a stable limit cycle solution are given. Meanwhile, we also analysed the Hopf bifurcation direction, which is very important for parameter settings in notch filter feedback control applications. Finally, we apply the notch filter feedback control methods to the electronic circuit experiments and numerical simulations based on the theoretical analysis. The controlling results of notch filter feedback control method well prove the feasibility and reliability of the theoretical analysis.     

Two-dimensional non-spatial filtering based on holographic Bragg gratings

The filter made up of two gratings performs as a two-dimensional non-spatial filtering. This paper reports that the volume Bragg gratings are fabricated by interfering two collimated coherent laser beams in photopolymer. Diffraction efficiency of a single grating is up to 78% in Bragg's condition, then a two-dimensional non-spatial filter, which consists of two volume Bragg gratings and a half-wave plate, enables the laser beam filtered in two dimensions with the diffraction efficiency of 54%. The Bragg's condition and effect of polarisation on performances of the two-dimension filter are also discussed.     

Defect-induced failure of optical coating filters

Optical filters composed of Ag, Al₂O₃, and ZnSe films were prepared on BK7 substrates by evaporation. By employing spectrophotometer, microscope, scanning electron microscope (SEM), and energy dispersive spectrum (EDS) analysis, the moisture-dependent stability of the samples was tested. The experimental results revealed that filter failure often occurs initially at defect sites. Small sputtering particles and pinhole are found to be two types of defects that induced the optical coating filter failure. The mechanisms of the defect-induced failure of the filters also are discussed in the article.     

Monte Carlo simulations for 20 MV X-ray spectrum reconstruction of a linear induction accelerator

To study the spectrum reconstruction of the 20 MV X-ray generated by the Dragon-I linear induction accelerator, the Monte Carlo method is applied to simulate the attenuations of the X-ray in the attenuators of different thicknesses and thus provide the transmission data. As is known, the spectrum estimation from transmission data is an ill-conditioned problem. The method based on iterative perturbations is employed to derive the X-ray spectra, where initial guesses are used to start the process. This algorithm takes into account not only the minimization of the differences between the measured and the calculated transmissions but also the smoothness feature of the spectrum function. In this work, various filter materials are put to use as the attenuator, and the condition for an accurate and robust solution of the X-ray spectrum calculation is demonstrated. The influences of the scattering photons within different intervals of emergence angle on the X-ray spectrum reconstruction are also analyzed.     

干涉型光纤传感器相位生成载波解调方法改进与研究

提出了基于干涉型光纤传感器的相位生成载波解调方法（PGC）的改进方法,通过算法上的改进和增加抗混叠滤波器,有效地改善了解调结果,并大大降低了系统的采样频率,结论对设计干涉型光纤传感器解调系统有重要的参考意义